Rust conventor

Characteristic:

Product is intended for pretreatment against rust on metal surfaces before it will be coating with paint. Works effectively, if thickness of the rust layer does not exceed 100 microns.
Can be used in car repairing and for metal constuction and container surface preparations before it will be primed or painted.

Use:

Rust conventor should be applied on clean surface by brush.
Consumption is from 0.1 till 0.17 l/m². Paint applying should be done not earlier than 24 hours after the converter was applied. If there is a loose layer on the surface then it should be wirebrushed before applying paint coating. Before applying the paint coating surface should be primed with ''LARAPRIM'' or ''LARAPRIM-M'' primer.

Security measures:
S2:
Keep out of the reach of children.
S24/25: Avoid contact with skin and eyes.
S26: In case of contact with eyes, rinse immediately with plenty of water and seek medical advice.
S37: Wear suitable gloves.
S46: If swallowed, seek medical advice immediately and show this container or label.
S61: Avoid release to the environment. Refer to special instructions/safety data sheet.

Risk factors:

Products contain zinc Phosphate, orthophosphoric acid, n-butalon, acetone.

R36/38: Irritating to eyes and skin.
R67: Vapours may cause drowsiness and dizziness.
R52/53: Harmful to aquatic organisms, may cause long-term adverse effects in the aquatic environment.

Back to list