Alkyd enamel

CHARACTERISTIC

Alkyd enamel. For wooden and metal indoor and outdoor surface painting. It also can be used for rock and plaster indoor painting.

SURFACE PREPARATION

Surface must be dry, without grease, clean and non-rusted. If surface was covered with paint before, then old layers of cover should be removed with sandpaper or using paint stripper LARAFĒNS. Shining surface, if it is possible, should be polished till it became matt. Roughness should be puttied.

PRIMING

Metal surfaces should be primed with LARAGRUNTS primer (internal work) or LARAPRIM (outdoor work), wooden – with LAZUROLS BASE (internal work) or TEKSTUROLS BASE (outdoor work), dry coating – with LARAKRILS BASE.

INFLICTION

Before using enamel, it should be mixed and diluted with solvent to a viscosity if needed. Apply enamel in 1-2 layers. Each layer should be dried for a no less than 24 hours. Working tools should be cleaned with solvent.

Saistviela

Alkīdsveķi

Šķīdinātājs

Vaitspirits

Spīduma pakāpe

Spīdīga, pusmatēta

Krāsa

Plaša krāsu gamma

Darbarīki

Ota, veltnītis, smidzinātājs

Patēriņš (vienai kārtai)

1 l/ 9-11 m2

Žūšanas laiks pie t°+20°C un relatīvā gaisa mitruma 50%

24 stundas

Iepakojums

1 l; 31; 10 l; 20 l

Glabāšana

12 mēneši, vēsā vietā. Salizturīga

.

 

SECURITY MESURES:

S2: Keep out of the reach of children.

S23: Do not inhale spray.

S24: Avoid contact with skin.

S62: If swallowed, do not induce vomiting: seek medical advice immediately and show this container or label where possible.

RISC FACTORS:

Contains white-spirit.
R10: Flammable.
R65: Harmful: may cause lung damage if swallowed.

Back to list