Pentaftal vanish for wooden surfaces

CHARACTERISTIC:

Pentaftal vanish for wooden surfaces. Creates light coating. Varnish is intended for indoor and outdoor works.

SURFACE PREPARATION:

Surface should be dry and clean. If there is an old varnish coating on wooden surface, then it should be removed. The surface should be grind with sandpaper till a matt and thoroughly vacuumed.

PRIMING:

Previously non-varnish surface should be primed with mix of varnish and white-spirit in proportion 10:1. In places with high level of humidity for priming should be used TEKSTUROLS BASE. Apply in 1 layer with brush or paint roller. Leave for drying, and then slightly grind with sandpaper and vacuum.

IMPLICTION:

Use varnish only at room temperature. Floor temperature should be at 15-25°С. Before applying the varnish it should be stirred. While applying the varnish drafts and direct sun rays should be avoided. Apply in 2 layers with intermediate drying of each layer for no less than 24 hours. Work tools should be cleaned with solvent.

SECURITY MESURES:

S2: Keep out of the reach of children.

S23: Do not breathe vapour.

S24: Avoid contact with skin.

S62: If swallowed, do not induce vomiting: seek medical advice immediately and show this container or label where possible.

RISC FACTORS:

Contains white-spirit.

R10: Flammable.

R65: Harmful: may cause lung damage if swallowed.

Back to list