Urethane Alkyde Varnish for floor


Urethane Alkyde Varnish creates light coating for floor surface with high hardness and durability. Intended for normaly exploited wooden and parquet indoor floor varnishing.


Surface should be dry and clean. If there is an old varnish coating on wooden surface, then it should be removed. The surface should be grind with sandpaper till a matt and thoroughly vacuumed. Fresh concrete surface should be dryed for no less than 21 days, and then grinded.


Previously non-varnish surface should be primed with mix of varnish and white-spirit in proportion 10:1. In places with high level of humidity for priming should be used TEKSTUROLS BASE. Apply in 1 layer with brush or paint roller. Leave for drying, and then slightly grind with sandpaper and vacuum.


Use varnish only at room temperature. Floor temperature should be at 15-25°С. Before applying the varnish it should be stirred. While applying the varnish drafts and direct sun rays should be avoided. Apply in 2 layers with intermediate drying of each layer for no less than 24 hours. Work tools should be cleaned with solvent.

Binder Urethane Alkyd Resin
Solvent White-spirit
Gloss level Glossy and half-matt
Work tools Brush, paint roller
Расход (на один слой) 1 l / 6-8 m2
Drying time at a temperature +20°C and 50% RH, against dust 2 hours
Full drying 4 hours
Final hardening 1 week
Package 1 l; 3 l


S2: Keep out of the reach of children.

S23: Do not breathe vapour.

S24: Avoid contact with skin.

S62: If swallowed, do not induce vomiting: seek medical advice immediately and show this container or label where possible.


Contains white-spirit.

R10: Flammable.

R65: Harmful: may cause lung damage if swallowed.

Back to list